Our Cisco 300-410 dumps are key to get success. More than 80000+ success stories.
Clients Passed Cisco 300-410 Exam Today
Passing score in Real Cisco 300-410 Exam
Questions were from our given 300-410 dumps
Which configuration adds an IPv4 interface to an OSPFv3 process in OSPFv3 address family configuration?
A. Router ospf3 1 address-family ipv4
B. Router(config-router)#ospfv3 1 ipv4 area 0
C. Router(config-if)#ospfv3 1 ipv4 area 0
D. Router ospfv3 1 address-family ipv4 unicast
What is a prerequisite for configuring BFD?
A. Jumbo frame support must be configured on the router that is using BFD.
B. All routers in the path between two BFD endpoints must have BFD enabled.
C. Cisco Express Forwarding must be enabled on all participating BFD endpoints.
D. To use BFD with BGP, the timers 3 9 command must first be configured in the BGProuting process.3332
Which two protocols can cause TCP starvation? (Choose two)
What is the output of the following command: show ip vrf
A. Show's default RD values
B. Displays IP routing table information associated with a VRF
C. Show's routing protocol information associated with a VRF.
D. Displays the ARP table (static and dynamic entries) in the specified VRF
An engineer configured the wrong default gateway for the Cisco DNA Center enterprise interface during the install. Which command must the engineer run to correct the configuration?
A. sudo maglev-config update
B. sudo maglev install config update
C. sudo maglev reinstall
D. sudo update config install
Which command displays the IP routing table information that is associated with VRF-Lite?
A. show ip vrf
B. show ip route vrf
C. show run vrf
D. show ip protocols vrf
Which statement about route distinguishers in an MPLS network is true?
A. Route distinguishers allow multiple instances of a routing table to coexist within the edge router.
B. Route distinguishers are used for label bindings.
C. Route distinguishers make a unique VPNv4 address across the MPLS network.
D. Route distinguishers define which prefixes are imported and exported on the edgerouter.
Which statement about IPv6 RA Guard is true?
A. It does not offer protection in environments where IPv6 traffic is tunneled.
B. It cannot be configured on a switch port interface in the ingress direction.
C. Packets that are dropped by IPv6 RA Guard cannot be spanned.
D. It is not supported in hardware when TCAM is programmed.
Which command allows traffic to load-balance in an MPLS Layer 3 VPN configuration?
A. multi-paths eibgp 2
B. maximum-paths 2
C. Maximum-paths ibgp 2
D. multi-paths 2
Which Cisco VPN technology can use multipoint tunnel, resulting in a single GRE tunnel interface on the hub, to support multiple connections from multiple spoke devices?
C. Cisco Easy VPN
Which two statements about redistributing EIGRP into OSPF are true? (Choose two)
A. The redistributed EIGRP routes appear as type 3 LSAs in the OSPF database
B. The redistributed EIGRP routes appear as type 5 LSAs in the OSPF database
C. The administrative distance of the redistributed routes is 170
D. The redistributed EIGRP routes appear as OSPF external type 1
E. The redistributed EIGRP routes as placed into an OSPF area whose area ID matchesthe EIGRP autonomous system number
F. The redistributed EIGRP routes appear as OSPF external type 2 routes in the routing table
Which protocol is used to determine the NBMA address on the other end of a tunnel when mGRE is used?
Which protocol is used in a DMVPN network to map physical IP addresses to logical IP addresses?
Which statement about MPLS LDP router ID is true?
A. If not configured, the operational physical interface is chosen as the router ID even if a
loopback is configured.
B. The loopback with the highest IP address is selected as the router ID.
C. The MPLS LDP router ID must match the IGP router ID.
D. The force keyword changes the router ID to the specified address without causing any impact.
An engineer is trying to copy an IOS file from one router to another router by using TFTP. Which two actions are needed to allow the file to copy? (Choose two.)
A. Copy the file to the destination router with the copy tftp: flash: command
B. Enable the TFTP server on the source router with the tftp-server flash: command
C. TFTP is not supported in recent IOS versions, so an alternative method must be used
D. Configure a user on the source router with the username tftp password tftp command
E. Configure the TFTP authentication on the source router with the tftp-server authentication local command
Which component of MPLS VPNs is used to extend the IP address so that an engineer is able to identify to which VPN it belongs?
A. VPNv4 address family
What is a limitation of IPv6 RA Guard?
A. It is not supported in hardware when TCAM is programmed
B. It does not offer protection in environments where IPv6 traffic is tunneled.
C. It cannot be configured on a switch port interface in the ingress direction
D. Packets that are dropped by IPv6 RA Guard cannot be spanned
Which attribute eliminates LFAs that belong to protected paths in situations where links in a network are connected through a common fiber?
A. shared risk link group-disjoint
What is a function of IPv6 ND inspection?
A. It learns and secures bindings for stateless autoconfiguration addresses in Layer 3 neighbor tables
B. It learns and secures bindings for stateless autoconfiguration addresses in Layer 2 neighbor tables
C. It learns and secures bindings for stateful autoconfiguration addresses in Layer 2 neighbor tables.
D. It learns and secures bindings for stateful autoconfiguration addresses in Layer 3 neighbor tables.
Which list defines the contents of an MPLS label?
A. 20-bit label; 3-bit traffic class; 1-bit bottom stack; 8-bit TTL
B. 32-bit label; 3-bit traffic class; 1-bit bottom stack; 8-bit TTL
C. 20-bit label; 3-bit flow label; 1-bit bottom stack; 8-bit hop limit
D. 32-bit label; 3-bit flow label; 1-bit bottom stack; 8-bit hop limit
Which command is used to check IP SLA when an interface is suspected to receive lots of traffic with options?
A. show track
B. show threshold
C. show timer
D. show delay
Which protocol does MPLS use to support traffic engineering?
A. Tag Distribution Protocol
B. Resource Reservation Protocol
C. Border Gateway Protocol
D. Label Distribution Protocol
Which protocol does VRF-Lite support?
What is an advantage of using BFD?
A. It detects local link failure at layer 1 and updates routing table.
B. It detects local link failure at layer 2 and updates routing protocols.
C. It has sub-second failure detection for layer 1 and layer 3 problems.
D. It has sub-second failure detection for layer 1 and layer 2 problems.
Which is statement about IPv6 inspection is true?
A. It teams and secures bindings for stateless autoconfiguration addresses in Layer 3
B. It learns and secures bindings for stateful autoconfiguration addresses in Layer 3 neighbor tables
C. It teams and secures bindings for stateful autoconfiguration addresses in Layer 2 neighbor tables
D. It team and secures binding for stateless autoconfiguration addresses in Layer 2 neighbor tables.
While troubleshooting connectivity issues to a router, these details are noticed: Standard pings to all router interfaces, including loopbacks, are successful. Data traffic is unaffected. SNMP connectivity is intermittent. SSH is either slow or disconnects frequently. Which command must be configured first to troubleshoot this issue?
A. show policy-map control-plane
B. show policy-map
C. show interface | inc drop
D. show ip route
A network engineer needs to verify IP SLA operations on an interface that shows on indication of excessive traffic. Which command should the engineer use to complete this action?
A. show frequency
B. show track
C. show reachability
D. show threshold